Pilot's Operating Handbook
Section 7
Description
Edition 0 - October 31, 2013
Rev. 4
Page 7.3.34
Use of cargo nets
Net inspection
Bef
ore each use, visually inspect net for :
- webbing condition,
- seam condition of tensioning strap,
- metallic part condition.
Installation instructions
Tensioning straps must be installed so that they make a V with a minimum angle of40°
between both strands attached on the net. The net must be properly tight.
Damage acceptance criteria
If any damage is detected, such as :
- damage or absence of hook, buckle or stud on tensioning strap : strap must
mandatorily be discarded and replaced,
- webbing frayed or cut on less than 30 % of its surface : reduce maximum load
by 50 %,
- seam of vertical net tensioning straps damaged on less than 30 % of its length :
reduce maximum load by 50 %,
- seam of tensioning straps attached on the rails damaged on less than 30 % of
its length : reduce maximum load by 50 %,
- beyond 30% damage for above-mentioned cases, defective element must
mandatorily be discarded and replaced,
- netting cut or torn on less than 3.9 in (100 mm) : still serviceable, no impact,
- netting cut or torn on more than 3.9 in (100 mm) : do not carry small objects
which dimensions are smaller than 4.9 x 4.9 x 4.9 in (125 x 125 x 125 mm).
To Next Page
Loading...
