Daher TBM 900 - Bat Amp; Bat off

Pilot's Operating Handbook
Section 3
Emergency procedures
EASA Approved
Edition 0 - October 31, 2013
Rev. 4
Page 3.9.3
BAT AMP
Indicates that battery current is over 50 A while on ground.
After starting the engine with airplane power, a battery charge over 50 amperes is
normal.
▲ CAUTION ▲
Do not take off if battery charge is over 50 A.
▲
If this indication remains steady at a high value :
It may be due to a battery or generation system failure.
End of procedure.
BAT OFF
Indicates that :
- the SOURCE selector has been positioned on OFF or
- the battery plug is disconnected
► Fly the airplane ◄
1 - SOURCE selector OFF. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2 - SOURCE selector BATT. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
If warning persists :
► Land as soon as possible ◄
3 - Airplane mains voltage Monitor. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
End of procedure.
PIM - DO NOT USE FOR FLIGHT OPERATIONS