Pilot's Operating Handbook
Section 4
Normal procedures
EASA Approved
Edition 0 - October 31, 2013
Rev. 4
Page 4.4.54
Cruise 1/2
1 - Altimeters setting Check. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2 - Autopilot Check. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Autopilot status and yaw damper ON
▲ CAUTION ▲
Observe TRQ / Ng / Np / ITT / OIL T° and PSI limitations.
Use optimum torque and / or refer to tables in chapter 5.8.
▲
3 - TRQ adjustment / ITT / Ng Check. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Adjust according to engine operation tables - chapter 5.8
or to cruise index on the PFDs
● NOTE ●
Eng
ine operation tables (chapter 5.8) give torque to be applied according to
OAT, in order not to exceed authorized maximum power.
When INERT SEP switch is OFF, a more accurate setting of torque must then
be performed according to cruise performance tables presented in
chapter 5.11.
●
4 - EIS Check. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5 - CAS display Check. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6 - Pressurization Check. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Regularly check fuel gages for :
7 - Consumption
8 - Expected fuel at destination
>> Before fuel sequencer evolution (Pre-MOD70-0402-28)
9 - Tank automatic change every 10 minutes
>> After fuel sequencer evolution (Post-MOD70-0402-28)
10 - Tank automatic change every 5 minutes
>> All
11 - Imbalance
Max. imbalance 15 USG
Continue ►
To Next Page
Loading...
