Pilot's Operating Handbook
Section 8
Handling, servicing and maintenance
Edition 0 - October 31, 2013
Rev. 4
Page 8.9.6
6) Pull up and hold L.H. and R.H. rings (2) and turn knobs (8) by 90° in
order to insert locks (3) into rail (5) apertures.
7) Make sure the seat is correctly locked on rails (5).
8) Tilt seat forward, hold it and slip strap (9) around the locking control
hinge pin. Screw quick links (7).
9) Tilt the seat rearward and lock it using seat tilting handle (1).
10) Fold up the backrest and lock it using backrest tilting handle (6).
11) Slide properly the carpet under the seat.
12) Remove protective covers.
G - Reconditioning
1) Make sure the work area is clean and free from debris.
2) Determine weight and balance - refer to section 6.
3 -- Additional configurations
▲ WARNING ▲
Removed seats can only be installed at their original location.
Rear seat (L.H. or R.H.) is the only one which can be installed in
cabin axis, on both central rails – refer to section 7.
▲
● NOTE ●
Many combinations of accommodations are authorized with seats (rear and
intermediate) by pilot or service centers and cabinet(s) by service centers only.
However, the pilot must ensure that he gets all necessary authorizations from
his regulatory authority.
●
● NOTE ●
To remove or install these elements, use paragraph 1 or 2 – refer to table 1.
●
● NOTE ●
After these operations, determine weight and balance with the new C.G. -
refer to section 6.
●
To Next Page
Loading...
