User's Manual
127
Figure 5-81 Manual add
Step 2 Configure the settings for the manual adding device parameters.
Table 5-31 Manual add parameters
Parameter Description
Channel
In the
Channel
list, select the channel that you want use on the Device to
connect the remote device.
Manufacturer In the
Manufacturer
list, select the manufacturer of the remote device.
IP Address
In the
IP Address
box, enter the IP address of remote device.
The default is 192.168.0.0 which the system cannot connect to.
RTSP Port
The default value setting is 554. You can enter the value according to your
actual situation.
HTTP Port
The default value setting is 80. You can enter the value according to your
actual situation.
If you enter other value, for example, 70, and then you should enter 70
after the IP address when logging in the Device by browser.
TCP Port
The default value setting is 37777. You can enter the value according to
your actual situation.
Username Enter the username of the remote device.
Password Enter the password of the user for the remote device.
To Next Page
Loading...
Need help?
General
