User's Manual
168
Parameter Description
PIR Alarm
PIR function helps enhancing the accuracy and validity of motion
detect. It can filter the meaningless alarms that are activated by the
objects such as falling leaves, flies. The detection range by PIR is
smaller than the field angle.
PIR function is enabled by default if it is supported by the cameras.
Enabling PIR function will get the motion detect to be enabled
automatically to generate motion detection alarms; if the PIR function
is not enabled, the motion detect just has the general effect.
●
Only when the channel type is CVI, the PIR function can be
enabled.
●
If the camera does not support PIR function, it will be unusable.
●
If the Device does not support PIR function, it will not be
displayed on the page.
Schedule Define a period during which the motion detection is active.
Anti-Dither
Configure the time period from end of event detection to the stop of
alarm.
Alarm-out Port
Click
Setting
to configure the parameters.
●
General Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
●
External Alarm: Enable alarm activation through the connected
alarm box.
●
Wireless Siren: Enable alarm activation through devices
connected by USB gateway or camera gateway.
Post-Alarm
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 0 seconds to 300
seconds, and the default value is 10 seconds. If you enter 0, there will
be no delay.
Show Message
Select the
Show Message
checkbox to enable a pop-up message in
your local host PC.
Report Alarm
Select the
Report Alarm
checkbox to enable the system to upload
the alarm signal to the network (including alarm center) when an
alarm event occurs.
Send Email
Select the
Send Email
checkbox to enable the system to send an
email notification when an alarm event occurs.
To use this function, make sure the email function is enabled in
Main
Menu
>
NETWORK
>
Email
.
Record Channel
Select the channel(s) that you want to record. The selected channel(s)
starts recording after an alarm event occurs.
The recording for motion detection and auto recording function
must be enabled.
To Next Page
Loading...
Need help?
General
