User's Manual
174
Figure 5-128 Disk
Step 2 Configure the settings for the HDD event.
Table 5-41 HDD event settings
Parameter Description
Event Type
In the
Event Type
list, select
No Disk
,
Disk Error
, or
Low Space
as the
event type.
Enable Enable or disable the HDD event detection function.
Alarm-out Port
Click
Setting
to configure the parameters.
●
Local Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
●
Extension Alarm: Enable alarm activation through the connected
alarm box.
●
Wireless Siren: Enable alarm activation through devices connected by
USB gateway or camera gateway.
Post-Alarm
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 10 seconds to 300
seconds, and the default value is 10 seconds.
Show Message
Select the
Show Message
checkbox to enable a pop-up message in your
local host PC.
Report Alarm
Select the
Report Alarm
checkbox to enable the system to upload the
alarm signal to the network (including alarm center) when an alarm event
occurs.
To Next Page
Loading...
Need help?
General
