User's Manual
265
Figure 5-227 SNMP
Step 2 Configure the settings for the SNMP parameters.
Table 5-62 SNMP parameters
Parameter Description
Enable Enable the SNMP function.
Version
Select the checkbox of SNMP version(s) that you are using.
The default version is
V3
. There is a risk of select V1 or V2.
SNMP Port Indicates the monitoring port on the agent program.
Read Community
Indicates the read/write strings supported by the agent program.
Write Community
Trap Address
Indicates the destination address for the agent program to send
the Trap information.
Trap Port
Indicates the destination port for the agent program to send the
Trap information.
Read-Only Username
Enter the username that is allowed to access the Device and has
the "Read Only" permission.
Read/Write Username
Enter the username that is allowed to access the Device and has
the "Read and Write" permission.
Authentication Type Includes MD5 and SHA. The system recognizes automatically.
Authentication Password
Enter the password for authentication type and encryption type.
The password should be no less than eight characters.
Encryption Password
Encryption Type
In the
Encryption Type
list, select an encryption type. The
default setting is CBC-DES.
Step 3 Compile the two MIB files by MIB Builder.
To Next Page
Loading...
Need help?
General
