User’s Manual
9
Set WAN connection type Figure 3-3
Table 3-1 Parameters to be configured when Static IP as the WAN connection type
Set IP address by your own or ISP assigns.
Set subnet mask by your own or ISP assigns.
Set gateway by your own or ISP assigns
Set static DNS by your own or ISP assigns.
Select online detection mode to detect whether the
Internet connection is active. The following detection
mode are available: None (disable this function), Ping,
Route and TCP.
Set time interval between two detections, expressed by
seconds.
Primary Detection Server IP
Enter the IP address of the server which is used to
response the Router’s detection packet.
Backup Detection Server IP
Enable Dial Failure to Restart
Whether to enable the restart of the Router when
dial-up fails.
To Next Page
Loading...