Dahua DH-WM4700-O - Page 16

User’s Manual
10
Table 3-2 Parameters when Automatic Configuration-DHCP as the WAN connection type
Parameter
Description
Keep Online Detection
Select online detection mode to detect whether the
Internet connection is active. The following detection
modes are available: None (disable this function),
Ping, Route and TCP.
Detection Interval
Set time interval between two detections, expressed by
seconds.
Primary Detection Server IP
Enter the IP address of the server which is used to
response the Router’s detection packet.
Backup Detection Server IP
Enable Dial Failure to Restart
Whether to enable the restart of the Router when
dial-up fails.
Table 3-3 Parameters to be configured when dhcp-4G as the WAN connection type
Parameter
Description
User Name
Enter the user name for login to the Internet.
Password
Enter the password for login to the Internet.
APN
Enter the access point name of your ISP.
Fixed WAN IP
Set whether to enable fixed WAN IP. If enabled, enter
the WAN IP address.
Allow these authentication
Supports PAP and CHAP.
Connection type
Supports the following options are available: Auto,
Force 3G, Force 2G, Prefer 3G, Prefer 2G and Force
4G.
PIN
Enter PIN code of the SIM card.
Keep Online Detection
Select online detection mode to detect whether the
Internet connection is active. The following detection
modes are available: None (disable this function),
Ping, Route and TCP.
Detection Interval
Set time interval between two detections, expressed by
seconds.
Primary Detection Server IP
Enter the IP address of the server which is used to
response the Router’s detection packet.
When you choose Route or Ping as the detection
mode, make sure that Primary Detection Server IP
and Backup Detection Server IP are valid and stable,
because they have to response the detection packet
frequently.
Backup Detection Server IP
Enable Dial Failure to Restart
Whether to enable the restart of the Router when
dial-up fails.