User’s Manual
33
Enable PPTP server Figure 3-23
Table 3-17 Description of PPTP server parameters
Set whether to enable broadcast or not.
Set whether to mandatorily enable MPPE (Microsoft Point-to-Point
Encryption) encription of PPTP data.
Enter IP address of the Router as PPTP server, which should be
different from the LAN address.
Enter IP addresses that are assigned to the clients. The format is
xxx.xxx.xxx.xxx-xxx.
User name and password of the client when using PPTP service.
Client IP must be different with IP assigned by Router DHCP.
The format of CHAP Secrets: "user * password *".
Click Save to save the configuration. Step 4
Click Apply Settings to apply the configuration. Step 5
(Optional) Click Cancel Changes to cancel the configuration. Step 6
3.6.1.2 PPTP Client
Log in to the web interface of the Router. Step 1
To Next Page
Loading...