Dahua DH-WM4700-O - Page 40

User’s Manual
34
In the left navigation menu, select VPN > PPTP. Step 2
In PPTP Client section, enable PPTP Client, and set parameters. Step 3
Enable PPTP client Figure 3-24
Table 3-18 Description of PPTP client parameters
Parameter
Description
Server IP or DNS Name
Enter IP address or DNS name of PPTP server.
Remote Subnet
Enter the internal network of the remote PPTP server.
Remote Subnet Mask
Enter subnet mask of the remote PPTP server.
MPPE Encryption
Set whether to enable MPPE encryption.
MTU
Maximum Transmission Unit.
The range is 0–1500.
MRU
Maximum Receive Unit.
The range is 0–1500.
NAT
Network Address Translation.
Set whether to enable NAT.
Fixed IP
Set whether to enable fixed IP. It is disabled by default.
User Name
Enter user name to log in to PPTP server.
Password
Enter password to log in to PPTP server.
Click Save to save the configuration. Step 4
Click Apply Settings to apply the configuration. Step 5
(Optional) Click Cancel Changes to cancel the configuration. Step 6