301
Figure 5-32
5.8.2.6 PPPoE
The PPPoE interface is shown as in Figure 5-33.
Input the PPPoE user name and password you get from the IPS (internet service provider) and enable
PPPoE function. Please save current setup and then reboot the device to get the setup activated.
Device connects to the internet via PPPoE after reboot. You can get the IP address in the WAN from the
IP address column.
Please note, you need to use previous IP address in the LAN to login the device. Please go to the
IP address item to via the device current device information. You can access the client-end via
this new address.
Figure 5-33
5.8.2.7 DDNS
The DDNS interface is shown as in Figure 5-34.
To Next Page
Loading...
Need help?
General
