When Work Mode is Auto, then you can automatically turn on or turn off
spotlight according to time or brightness.
Time: Set the period during which the spotlight is enabled. Independent
config 7 days a week, each day supports 6 periods.
Brightness: Set brightness default value. Spotlight is enabled when
environmental brightness is lower than the default value and the spotlight
is disabled when it is higher than default value.
Click OK to finish configuration.
5.4.1.7 BW List
5.4.1.7.1 White List Setup
Enable white list. When the system detects the vehicles in the white list, then it will enable
open-barrier mode and set white list matching function.
Select Setting > ITC > BW List > White List Setup.
The White List Setup interface is displayed. See Figure 5-35.
White List Setup
Configure parameters according to actual requirement. Please refer to 0 for more
details.
White list setup parameters description
After it is selected, you can set matching character and min length. The
plates which meet the matching condition will be considered as white list
vehicle. It is unnecessary for each character to totally match the plate
number which exists in white list data.
Match the selected character bit and the unselected characters will not
be analyzed.
When the number of matched characters meets the value, then it will be
considered as white list vehicle regardless of whether other characters
match.
Click OK to finish configuration.
To Next Page
Loading...
