31
Figure 5-20
Connect WIFI. 2.
The system has 2 access ways as follows.
◇ At “WLAN” interface, select WIFI, click “Wireless IP” tab to enter “Local IP”,
“Subnet Mask” and “Gateway”, and press [OK].
◇ At “WLAN” interface, select WIFI, click “Wireless IP” tab, press to
enable DHCP function and obtain IP info automatically, as shown in Figure
5-21.
To obtain IP info with DHCP function, use a router with DHCP function.
Figure 5-21
5.1.3.3 VTH Config
Set VTH “Room No.”, “Type” and “Master IP” info.
Press [Setting] for more than 6 seconds. Step 1
To Next Page
Loading...