129
Figure 3-114
Motion detect here only has relationship with the sensitivity and region setup. It has no relationship
with other setups.
3.10.1.2 Video Loss
After connected the system to the remote device, system can generate an alarm once the remote
device has lost the video. System can trigger the corresponding alarm operations.
In Figure 3-110, select video loss from the type list. You can see the interface is shown as in Figure
3-115. This function allows you to be informed when video loss phenomenon occurred. You can
enable alarm output channel and then enable show message function.
You can refer to chapter 3.10.1.1Motion detect for detailed information.
Tips:
You can enable preset/tour/pattern activation operation when video loss occurs.
To Next Page
Loading...
