194
Step 5 View device info.
1) Run MIB Builder and MG-SOFT MIB Browser.
2) Compile the two MIB files with MIB Builder.
3) Load the compiled module to the software with MG-SOFT MIB Browser.
4) Enter the PC IP address into MG-SOFT MIB Browser and select the version to search.
5) Expand the tree list in MG-SOFT MIB Browser to view the device configuration information,
such as channel number and program version.
3.11.1.9 Multicast
Multicast setup interface is shown as in Figure 3-185.
Figure 3-185
Here you can set a multiple cast group. Please refer to the following sheet for detailed information.
IP multiple cast group address
-224.0.0.0-239.255.255.255
-“D” address space
The higher four-bit of the first byte=”1110”
Reserved local multiple cast group address
-224.0.0.0-224.0.0.255
-TTL=1 When sending out telegraph
-For example
224.0.0.1 All systems in the sub-net
224.0.0.2 All routers in the sub-net
224.0.0.4 DVMRP router
224.0.0.5 OSPF router
To Next Page
Loading...
