360
Step 2 Change corresponding information and then click Save button.
4.6.6.5.3 ONVIF User
When the camera from the third party is connected with the NVR via the ONVIF user, please use the
verified ONVIF account to connect to the NVR.
Step 1 From main menu->Setting->System->Account->ONVIF User.
Enter ONVIF user interface. See the following figure.
Figure 4-150
Step 2 Click Add user button.
Enter add user interface. See Figure 4-151.
Figure 4-151
Step 3 Set user name, password and then select group from the dropdown list.
Step 4 Click Save to complete setup.
Note
Click to change user information, click to delete current user.
4.6.6.6 Security
To enhance device network security and protect device data, please set the access right of the IP host (IP
host here refers to the IP PC or the server). After you enabled trusted sites function, only the IP listed
below can access current NVR.
If you enable blocked sites function, the following listed IP addresses cannot access current NVR.
To Next Page
Loading...
