266
Parameter Function
Encrypt
When the conn
ection protocol is ONVIF, enable the encryption function and
system transmits data in the encrypted mode.
Note
System supports this function when HTTPS is enabled in IPC.
Change IP
On the searched devices list, check one or more device(s) at the same time. Click Modify IP button, you
can see the following interface. See Figure 4-29
Please refer to the following sheet for log parameter information.
Parameter Function
DHCP Check the box here, system can auto allocate the IP
address. The IP address, subnet mask, default
gateway are reference only.
Static Check the box here, you can set IP address, subnet
mask, default gateway manually.
IP address/subnet
mask/default gateway
You can input corresponding information here.
User name/password
The account you login the remote device. Please
input here to password verification to change the
remote device password.
Incremental value
When you want to change several IP addresses,
once you input the IP address of the first device, the
IP address of the next device will increase
accordingly. For example, when the incremental
value is 1, if the IP address of the first device is
172.10.3.128, the IP address of the second device
will auto be set as 172.10.3.129.
Note
For the static IP address, system will alert you if there is any IP conflict. If you are changing several IP
addresses at the same time, system auto skip the conflicted IP and auto allocate again according to the
incremental value you set.
To Next Page
Loading...
