51
Figure 3-24
Step 2 Select Create RAID or Create Manually to create RAID type.
Create RAID
Click Create RAID. You do not need to select the disks and the system automatically
creates a RAID 5. Details are shown as follows:
Before the creation, there is no RAID and hotspare disk in the system. The system
creates RAID 5 and a hotspare disk at the same time.
Before the creation, there is no RAID in the system, but a hotspare disk is already
available. The system creates RAID 5 only and uses the existing hotspare disk.
Before the creation, there is RAID available in the system. The system breaks up the
original RAID and creates a new RAID 5 with other physical disks. The system uses
the existing hospare disk and does not create a new one again.
Create Manually
1. Select RAID type and select disks according to the system prompt.
2. Click Create Manually and the system prompts that all data will be cleared.
3. Click OK and the system performs the creation.
Note
When creating RAID 5 and RAID 6, you can adjust the RAID sync speed by selecting the
working mode of RAID 5 and RAID 6.
To Next Page
Loading...
