Interface Operation 46
Figure 6-9
Press [Add]. Step 4
Press wireless code button of wireless device. Please refer to wireless device user’s Step 5
manual for details.
After successful coding, display area info.
Press corresponding positions to set alarm status, enter delay and exit delay. Please Step 6
refer to Table 6-3 for details.
Press [Edit] to select a zone and press [Delete] to delete the selected area.
6.2.3.3 Alarm Output
After enabling alarm output, when other devices call this VTH, the alarm output device will
output alarm info.
Press [Setting]. Step 1
The system pops up “Password” prompt box.
Input login password and press [OK]. Step 2
Default login password is 123456. Please refer to “6.2.6.3 Password Setting“ for
details.
Select “Alarm > Output”. Step 3
The system displays “Output” interface, as shown in Figure 6-10.
To Next Page
Loading...
