Interface Operation 47
Figure 6-10
Press to enable alarm output function, and the icon becomes . Step 4
6.2.4 Mode Setting
Set area on/off status under different modes.
Area mode can be set only in disarm status.
Press [Setting]. Step 1
The system pops up “Password” prompt box.
Input login password and press [OK]. Step 2
Default login password is 123456. Please refer to “6.2.6.3 Password Setting“ for
details.
Press [Mode]. Step 3
The system displays “Mode” interface, as shown in Figure 6-11.
To Next Page
Loading...
