Interface Operation 48
Figure 6-11
Select arm mode in every tab. Step 4
Press in every area to add it into arm mode. Step 5
Multiple areas can be added into one arm mode simultaneously, whereas one area can
be added into different modes.
6.2.5 Forward Setting
Forward incoming calls.
Parameters at this interface are set on master VTH only, and extension VTH synchronizes with
master VTH.
Press [Setting]. Step 1
The system pops up “Password” prompt box.
Input login password and press [OK]. Step 2
Default login password is 123456. Please refer to “6.2.6.3 Password Setting“ for
details.
Press [Forward]. Step 3
The system displays “Forward” interface, as shown in Figure 6-12.
To Next Page
Loading...
