Dahua VTH5421 Series User Manual

Interface Operation 61
Figure 6-25
Add VTO or fence station. Step 4
 Add main VTO.
1) Enter main VTO name, VTO IP, “User Name” and “Password”.
2) Switch the “Enable Status” to be .
“User Name” and “Password” shall be consistent with WEB login user name and
password of VTO. Otherwise, it will fail to connect.
 Add sub VTO or fence station.
1) Enter sub VTO/fence station name, IP address, “User Name” and “Password”.
2) Switch the “Enable Status” to be .
Press / to add more sub VTOs/ fence stations.
6.3.5 Default
All parameters of the device, except IP address, can be restored to initial default values.
Press [Setting] for over 6 seconds. Step 1
The system pops up “Password” prompt box.
Enter the password set during initialization, and press [OK]. Step 2
Press [Default]. Step 3
The system displays “Default” interface.
Press [OK]. Step 4
The device reboots and enters initialization interface, representing successful
restoration.

Dahua VTH5421 Series Specifications

General

Brand	Dahua
Model	VTH5421 Series
Category	Intercom System
Language	English