Si01-501
Removal Procedure 145
Part 7
Removal Procedure
1. FT09/13DV2S, FT25/35DVM, FT25/35DSG.......................................146
1.1 Removal of Air Filter.............................................................................146
1.2 Removal of Front Panel........................................................................148
1.3 Removal of Front Grille ........................................................................150
1.4 Removal of Horizontal Blades and Vertical Blades ..............................153
1.5 Removal of Electrical Box ....................................................................156
1.6 Removal of PCB...................................................................................159
1.7 Removal of Drain Pan Unit...................................................................165
1.8 Removal of Fan Motor..........................................................................169
1.9 Removal of Heat Exchanger ................................................................171
1.10 Removal of Fan Rotor ..........................................................................174
2. FT15DV2S, FT50/60DSG ...................................................................177
2.1 Removal of Air Filter / Front Panel .......................................................177
2.2 Removal of Front Grille ........................................................................180
2.3 Removal of Horizontal Blades / Vertical Blades ...................................182
2.4 Removal of Electrical Box / PCB / Swing Motor ...................................184
2.5 Removal of Heat Exchanger ................................................................190
2.6 Removal of Fan Rotor / Fan Motor.......................................................193
3. R25/35DV1..........................................................................................195
3.1 Removal of Panels ...............................................................................195
3.2 Removal of Bellmouth and Left Side Plate...........................................197
3.3 Removal of Electrical Device Mounting Plate.......................................198
3.4 Removal of Propeller Fan and Fan Motor ............................................199
3.5 Removal of Sound Blanket...................................................................200
3.6 Removal of Partition Plate....................................................................202
3.7 Removal of Compressor.......................................................................204
4. R50DSG..............................................................................................205
4.1 Removal of Panels ...............................................................................205
4.2 Removal of Electrical Box ....................................................................206
4.3 Removal of Compressor.......................................................................209
5. R60DSG..............................................................................................211
5.1 Removal of the Panels and Plates .......................................................211
5.2 Removal of the Fan Motor / Propeller Fan ...........................................215
5.3 Removal of the PCB / Electrical Box ....................................................219
5.4 Removal of the Reactor........................................................................226
5.5 Removal of the Sound Blanket.............................................................228
5.6 Removal of the Electronic Expansion Valve.........................................230
5.7 Removal of the Compressor.................................................................231
Note:
The removal procedures for R09/13/15DV2S and R25/35DSG are not described.
To Next Page
Loading...
Need help?
General
