Si01-501 Instructions
System Configuration 67
16
TIMER Operation
To use ON TIMER operation
• Check that the clock is correct. If not, set the
clock to the present time (page 9.).
1. Press “ON TIMER button”.
is displayed.
blinks.
2. Press “TIMER Setting button” until
the time setting reaches the point
you like.
• Every pressing of either button increases or
decreases the time setting by 10 minutes.
Holding down either button changes the set-
ting rapidly.
3. Press “ON TIMER button” again.
•
The TIMER lamp lights up.
To cancel ON TIMER
operation
4. Press “CANCEL button”.
•
The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is shown below.
ATTENTION
In the following cases, set the timer again.
•
After a breaker has turned OFF.
•
After a power failure.
•
After replacing batteries in the remote controller.
TEMP
ON/OFF
POWERFUL
MODE
FAN
SWING
SILENT
SENSOR
ECONO
MOLD PROOF
TIMER
ON
CANCEL
OFF
C
ON
2
1, 3
4
(Example)
Present time: 11:00 p.m.
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
Combined
Display
To Next Page
Loading...
Need help?
General
