Instructions Si01-501
80 System Configuration
10
To set the clock
1. Press “CLOCK button”.
“ ” is displayed.
“” blinks.
2. Press “TIMER setting button”
to set the clock to the present
time.
Holding down “ ” or “ ” button rap-
idly increases or decreases the time dis-
play.
3. Press “CLOCK button”.
“ ” blinks.
Turn the breaker ON
• Turning ON the breaker opens the flap,
then closes it again. (This is a normal
procedure.)
NOTE
Tips for saving energy
•
Be careful not to cool the room too much.
Keeping the temperature setting at a moderate level helps save energy.
•
Cover windows with a blind or a curtain.
Blocking sunlight and air from outdoors increases the cooling effect.
•
Clogged air filters cause inefficient operation and waste energy. Clean them
once in about every two weeks.
Please note
•
The air conditioner always consumes 15-35 watts of electricity even while it is not operating.
•
If you are not going to use the air conditioner for a long period, for example in spring or autumn, turn the breaker
OFF.
•
Use the air conditioner in the following conditions.
•
Operation outside this humidity or temperature range may cause a safety device to disable the system.
C
TEMP
ON/OFF
POWERFUL
MODE
TIMER
FAN
SWING
ON
CANCEL
OFF
1, 3
2
Recommended temperature setting
For cooling:26˚C – 28˚C
Mode Operating conditions If operation is continued out of this range
COOL Outdoor temperature: 20 to 46 ˚C
Indoor temperature: 18 to 32 ˚C
Indoor humidity: 80% max.
•
A safety device may work to stop the operation.
•
Condensation may occur on the indoor unit and drip.
DRY Outdoor temperature: 20 to 46 ˚C
Indoor temperature: 18 to 32 ˚C
Indoor humidity: 80% max.
•
A safety device may work to stop the operation.
• Condensation may occur on the indoor unit and drip.
To Next Page
Loading...
Need help?
General
