Si01-501 Instructions
System Configuration 87
17
To use ON TIMER operation
• Check that the clock is correct. If not, set
the clock to the present time (page 10.).
1. Press “ON TIMER button”.
“ ” is displayed.
“” blinks.
2. Press “TIMER Setting button”
until the time setting reaches
the point you like.
• Every pressing of either button
increases or decreases the time setting
by 10 minutes. Holding down either but-
ton changes the setting rapidly.
3. Press “ON TIMER button”
again.
•
The TIMER lamp lights up.
To cancel ON TIMER operation
4. Press “TIMER CANCEL button”.
•
The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is shown below.
ATTENTION
In the following cases, set the timer again.
•
After a breaker has turned OFF.
•
After a power failure.
•
After replacing batteries in the remote controller.
C
TEMP
ON/OFF
POWERFUL
MODE
TIMER
FAN
SWING
ON
CANCEL
OFF
2
1, 3
4
Display
(Example)
Present time: 11:00 p.m.
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
Combined
To Next Page
Loading...
Need help?
General
