Si18-201
ii Table of Contents
NOTICE : Special specifications
Model RMK140JAVM has the following different specifications from the others. Take the important notes below. This
model is designed for cooling mode only, which means it has no heating functions at all.
★
★★
★Important points : The model is not equipped with the receiver circuit.
1) The heating mode is not available because the following parts are not built in.
2) The following control features are not available.
3) Change the following values for this model.
4) The model is not provided with the surplus refrigerant control function.
PART 5 (5) EVL : Liquid pipe motorized valve Page
103~105
(6) EVG : Gas pipe motorized valve
(8) Capillary tube for gas purge
(9) Check valve
(10) Check valve
PART 5 3.8 Defrost Operation Page 122
3.12 Peak Cut Control Page 128
3.23 Warm-Up Function Page 141
3.27 Cooling Outdoor Unit SC Control Page 151
3.30 SH Control in Cooling Operation Page 157
3.31 SC Control in Heating Operation Page 159
3.32 Heat Exchanger Isothermal Control in Heating Operation Page 161
3.34 Inter-BP Units Heating Heat Exchanger Isothermal Control Page 163
3.37 4-Way Valve Operation Page 166
PART 5 3.11.1 20sec
→
10sec Page 126
PART 6 See "1.7 Cooling operation (multi-room operation - without surplus refrigerant control function) ". Page 178
To Next Page
Loading...
Need help?
General