Daikin RoCon HP - Page 44

Operating instructions
44
Daikin RoCon HP
Daikin Controller
008.1420844_13 – 02/2016
6 x Parameter settings
HC Assignment Display only on connected room station:
Setting of the heating circuit ID for the room station (see chapter 4.1). This parameter
determines which heating circuit is to be operated with it.
The direct heating circuit of the Daikin Altherma EHS(X/H) is set as standard to heating
cir
cuit "0" (see section 6.12, parameter [Unmixed Circ Config]).
N E Off, 0 - 15 Off 1
Tab. 6-1 Parameter in rotary switch setting "Configuration" level "Setup"
Sub- level
Parameter Description Access Setting range
Min / Max
Factory
setting
Increment
BE HF