Troubleshooting ESIE02–01
3–6 Part 3 – Troubleshooting
3
1
3
4
5
1.3 Emergency Operation and Checking with the Wired Remote Control
Emergency
operation
When the remote control is not available or its battery is dead, you can use the emergency button on
the front panel of the indoor unit :
■ To start the automatic mode, press the emergency button.
■ To stop the automatic mode, press the button again.
Checking with the
wired remote
control
If the operation stops due to a malfunction, the remote control‘s operation LED flashes, and the remote
control displays the error code. The error code helps you to troubleshoot. See page 3–11, 3–12 and
3–13.