Dalsa S3-10-01k40-R User Manual

72 Spyder 3 CL User's Manual
03-032-20008-00 DALSA
Figure 25: Saving and Restoring Overview
4 sets of user
pixel coefficients
User
Settings
Current
Session
wus wpc,wfc,
rus lpc,
Factory
Settings
1 set of factory
pixel coefficients
For each camera operating mode:
Low Sensitivity
High Sensitivity Forward
High Sensitivity Reverse
Tall Pixel
Factory Settings
On first initialization, the camera operates using the factory settings. You can restore the
original factory settings at any time using the command
rfs.
User Settings
You can save or restore your user settings to non-volatile memory using the following
commands. Pixel coefficients are stored separately from other data.
• To save all current user settings to non-volatile memory, use the command
wus. The
camera will automatically restore the saved user settings when powered up.
Note:
While settings are being written to nonvolatile memory, do not power down camera
or camera memory may be corrupted.
• To restore the last saved user settings, use the command
rus.
• To save the current pixel coefficients, use the command
wpc and wfc.
• To restore the last saved pixel coefficients, use the command
lpc.
Current Session Settings
These are the current operating settings of your camera. To save these settings to non-
volatile memory, use the command
wus.

Dalsa S3-10-01k40-R Specifications

General

Brand	Dalsa
Model	S3-10-01k40-R
Category	Digital Camera
Language	English