84 Spyder 3 CL User's Manual
03-032-20008-00 DALSA
Syntax Parameters
Description
get sbr
Returns the speed of camera serial communication port.
get scb
Returns the set cable parameter.
get scd
Returns the ccd shift direction where:
0 = Forward CCD shift direction.
1 = Reverse CCD shift direction.
2 = Externally controlled direction control via CC3.
get sdo
t
Returns the digital offset value in DN for the tap
indicated.
t = Tap value. 0 for all taps or 1 to 2 for individual tap
selection.
get sem
Returns the current exposure mode:
2 = Internal SYNC, internal PRIN, programmable line
rate and exposure time using commands
ssf and set
3 = External SYNC, internal PRIN, maximum exposure
time
4 = Smart EXSYNC
5 = External SYNC and PRIN
6 = External SYNC, internal PRIN, programmable
exposure time
7 = Internal programmable SYNC, maximum exposure
time. Factory setting.
8 = Internal SYNC, internal PRIN, programmable
exposure time. Maximum line rate for exposure time.
get set
Returns the current exposure time in µs.
get sfc
x
Returns the FPN coefficient for the pixel number idicated.
x =pixel number within the range 1 to sensor pixel
count
.
get slt
Returns the current lower threshold value.
get spc
x
Returns the PRNU coefficient for the specified pixel
number.
x=pixel number within the range 1 to sensor pixel
count
.
get srm
Returns the readout mode:
0 = Auto.
1 = Dark current clear.
2 = Immediate readout. Does not clear dark current.
get ssb
t
Returns the current background subtract value.
t = Tap value. 0 for all taps or 1 to 2 for individual tap
selection depending on camera model.
get ssf
Returns the current line/frame rate in Hz.
get ssg
t
Returns the current digital gain setting.
t = tap selection, either 1 to 2 depending on camera
model, or
0 for all taps
To Next Page
Loading...
