Danfoss FC 102 - Page 108

NOTICE
Installations with cables connected in a common joint as
shown in the first example in the picture is only
recommended for short cable lengths.
NOTICE
When motors are connected in parallel, 1-02 Flux Motor
Feedback Source cannot be used, and 1-01 Motor Control
Principle must be set to Special motor characteristics (U/f).
130BB838.12
a
b
c
d
e
f
Illustration 6.41 Parallel Motor Connection
Electrical Installation
Design Guide
106 Danfoss A/S © Rev. 06/2014 All rights reserved. MG11BC02
66