1 Stripping length, 10 mm (0.4 in) 2 Strain relief
3 Grounding
4.7 Installing the microSD Card
Supported microSD card types:
l SD
l SDHC
l SDXC
The microSC card must be formatted for the file system FAT32. It is recommended to use SDHC type cards as they are preformatted to
FAT32.
1. Locate the microSD card hole on the control board of the control unit.
Figure 27: Location of the microSD Card
1 The microSD card
2. Push the new microSD card into the hole.
The contact area must face the text μSD on the right.
To remove the microSD card, push it. The microSD card pops out.
30 | Danfoss Drives Oy © 2024.09 AN484843731544en-000101 / 172K4825A
Installation Guide | iC7-Automation Air-cooled Enclosed Drives Control and Option Installation
To Next Page
Loading...
