Danfoss iC7 - Specifications; Tightening Torques; Cable Sizes; List of Cable Size Information

6 Specifications
6.1 Tightening Torques
Table 11: Tightening Torques
Tightening torqueFrame Bolt
Nm In-lb
M4 1.8 16
M5 2.7 24
FE9, FE10
M6 6 53
M8 20 180FE9, FE10, AE10, AE11, IE10, IE11
M10 40 350
M12 70 620FE9, FE10, AE10, AE11, IE10, IE11
Grounding bolt (M8) 13.5 120
6.2 Cable Sizes
6.2.1 List of Cable Size Information
 NOTICE
Use symmetrical cabling with system modules connected in parallel. Each module must have the same number of cables with an
equal cross-section.
The cable size tables for the enclosed drives can be found with these links.
l
6.2.2 Mains Cable Size Recommendations, 380–500 V
l 6.2.3 Motor Cable Size Recommendations, 380–500 V
l 6.2.4 Mains Cable Size Recommendations, UL 480 V
l 6.2.5 Motor Cable Size Recommendations, UL 480 V
l 6.2.6 Brake Cable Size Recommendations
l 6.2.7 Brake Cable Size Recommendations, UL
34 | Danfoss Drives Oy © 2024.09 AN484843731544en-000101 / 172K4825A
Installation Guide | iC7-Automation Air-cooled Enclosed Drives Specifications