Danfoss Metasys N2 Operating Instructions

Q
Quick
Menu..................................................................................................... 84
Menu mode........................................................................................ 75
Menu Mode........................................................................................ 84
Transfer of Parameter Settings when Using GLCP................. 3
R
RCD (Residual Current Device)...................................................... 43
Receiving the Frequency Converter........................................... 10
Relay Outputs..................................................................................... 118
Reset............................................................................................. 133, 138
Residual Current Device..................................................................... 7
RFI Switch............................................................................................... 56
RS-485 Bus Connection.................................................................... 76
S
Safe
Stop + Pilz Relay............................................................................... 43
Torque Off............................................................................................. 7
Safety note............................................................................................... 6
Screened/armoured........................................................................... 68
Screening of cables............................................................................ 45
Serial Communication.................................................................... 119
Shielded Cables.................................................................................... 57
Short circuit......................................................................................... 134
Sine-wave filter.................................................................................... 46
Software Version.................................................................................... 4
Space
Space.................................................................................................... 21
Heaters and Thermostat................................................................ 43
Speed Up/Down................................................................................... 69
Start/Stop............................................................................................... 69
Stator leakage reactance................................................................. 92
Status
Status.................................................................................................... 75
messages............................................................................................. 73
Supply voltage................................................................................... 136
Surroundings...................................................................................... 119
Switches S201, S202, and S801..................................................... 68
Switching frequency.......................................................................... 45
T
Terminal
54......................................................................................................... 138
Locations........................................................................................ 1, 24
Thermal Protection............................................................................... 4
Thermistor.................................................................................... 94, 134
Torque
Torque.................................................................................................. 56
Characteristics................................................................................ 116
for Terminals...................................................................................... 57
U
Unpacking.............................................................................................. 10
V
Voltage
imbalance......................................................................................... 133
level.................................................................................................... 117
reference via a potentiometer.................................................... 70
W
Warning against Unintended Start................................................ 6
Wire access............................................................................................. 21
Index VLT HVAC Drive FC 102 Operating Instructions
MG11F402 - Rev. 2013-12-16 143

Danfoss Metasys N2 Specifications

General

Brand	Danfoss
Model	Metasys N2
Category	DC Drives
Language	English