GB
PL
DANFOSS HEATING 11
Option 37 - Set time duration of override rule
(Option 36 set to 1 or 2)
This establishes the duration of a temperature
override available to the user. Press + until Option 37
is displayed, use V and Λ to select required setting.
Setting 0 Next event (factory setting)
Setting 1 1 hour
Setting 2 2 hours
Setting 3 3 hours
Setting 4 4 hours
Option 40 - Number of Events per Day (Heating)
This sets the thermostat to operate with either 2, 4 or
6 switching events per day or to run it in stat mode.
Press + until option 40 is displayed, use Λ or V to
select required setting.
1 Stat mode
2 Two switching events per day
4 Four switching events per day
6 Six switching events per day (factory setting)
Option 41 - Operating Mode (Heating) (option 40 set to 2, 4, or 6)
This sets the thermostat to operate using either
5/2 day or 24 hour mode. Press + until option 41 is
displayed, use Λ or V to select required setting.
7 7 Day programming (factory setting)
5-2 or A-B 5-2 Day programming or A-B programming
24 24 hour programming
Option 60 - Number of events per day (Hot Water)
This sets the number of Hot Water on/off switching
times per day. Press + until option 60 is displayed, use
Λ or V to select required setting.
Setting 1 1 on/off event per day
Setting 2 2 on/off events per day
Setting 3 3 on/off events per day (factory setting)
To Next Page
Loading...
Need help?
General
