Danfoss TP9000 - To Change between C and F Scaling; Thermostat Mode (Heating Mode Only); Changing the Clock Forwards and Backwards

TP9000
28
To change between °C and °F scaling
Press V and - together to toggle between °C and °F temperature
scaling.
Thermostat mode (Heating mode only)
a) A constant temperature of between 5-30°C can be selected if
required. This can provide frost protection for periods away from
home, it can also be used to provide untimed higher temperatures
if, for example, a family member is sick.
b) Press Λ and V together to enter thermostat mode. The default
setting is 5°C, but this can be reprogrammed, see User Advanced
Programming, step 10, (page 34).
c) A frost protection symbol (snowfl ake in a
shield) will appear in the display when the
selected temperature is equal to or less than the
programmed frost protection setting.
d) Use the Λ or V buttons to change the temperature away from the
programmed frost protection temperature to another value.
e) To return to automatic programming press both Λ and V together.
f) Alternately, Thermostat mode can be accessed via the MODE
button (see page 31)
Changing the clock forwards and backwards
This is handled automatically, however, if the manual changeover has
been selected (User Advanced Programming step 3 on page 34) follow
the instructions below.
To change from Summer to Winter (clocks back)
With clock display showing, press and hold - button until time moves
back.
To change from Winter to summer (clocks forward)
With clock display showing, press and hold + button until time moves
forward.