Danfoss TP9000 - User Advanced Programming Options; To access User Advanced Programming

GB
PL
DANFOSS HEATING 33
User Advanced
Programming Options
Important: The thermostat has been set in the factory to suit most
situations, however, there are additional optional settings which can
improve the comfort, convenience and energy eff ectiveness of your
thermostat. These are set in the User Advanced Programming and
Installer Advanced Programming modes.
To access User Advanced Programming
Press and hold V and PROG for 3 seconds. This will take you into
User Advanced Programming. Use + and - keys to scroll backwards
and forwards between options then Λ and V keys to change option
settings. The fl ashing digit on the right hand of the display indicates the
number of the selected option.
Option 1 - Enable or disable A/B programming
(Option 41 and/or 61 set to 5+2)
This enables or disables the A/B programming option.
Press + until Option 1 is displayed, use Λ and V to
select required setting.
Setting 0 Disabled, unit operates as 5+2
Setting 1 Enabled: activates A/B programming
Option 2 - Enable/Disable Advanced Programming (Option 41
and/or 61 set to 7 Day)
This option enables or disables the Advanced Copy
Functionality. Press + until option 2 is selected, use Λ
or V to select required setting
Setting 0 Advanced Copy disabled (standard copy mode)
Setting 1 Advanced Copy enabled