TP9000
24
Programming “B” programme days and events
a) Press DAY/HOL until the fi rst preset time
and temperature (Event 1 for Programme B)
appears in the display.
b) Use the + and - buttons to adjust the TIME (press and hold to
change in 10 minute increments).
c) Use the Λ and V buttons to adjust the required TEMPERATURE
(CH only).
d) Press NEXT to move to the next preset time and/or temperature
(Event 2).
e) Repeat steps b, c, & d to programme the remaining events.
Running the programme
Press PROG to return to previous RUN mode.
The Heating will now follow the times and
temperatures programmed.
Copy functions explained
There are 2 possible copy functions available. These are; Standard
Copy and Enhanced Copy. Copy functions are enabled/disabled in the
Advanced Programming Options (page 33)
Standard Copy: Pressing copy will copy the previous days events into
the displayed day. The unit will then display the 1st event for the new
day. This copy function is present only if the unit is set to run in 5+2 or
7 day mode.
To Next Page
Loading...
