GB
PL
DANFOSS HEATING 31
MODE Pressing this button will alternate between setting the
unit in OFF (Thermostat), AUTO or ALLDAY modes for
HEATING or ON, OFF, AUTO or ALLDAY modes for WATER.
In AUTO mode, all programmed events will run, whereas in
ALLDAY mode, only the fi rst and last events will run. If set
for two events per day for Heating, or one ON/OFF event
for Water then AUTO and ALLDAY modes are the same.
The display will show how many events are to run:
Indicates that unit is in ALLDAY or AUTO mode with 2
events per day for 1 On/Off for Hot Water.
Indicates that the unit is in AUTO mode with 4 events per
day for heat or 2 ON/OFF for Hot Water.
Indicates that the unit is in AUTO mode with 6 events per
day for heat or 3 for Hot Water.
ON Indicates Hot Water is permanently on (Applies to Hot
Water only)
OFF Indicates permanently off for Hot Water or Thermostat
mode (see page 28) for Heating
The INFO button is used to display information about
either the next programmed event for the currently
selected mode (central Heating or Hot Water) to display
the outdoor temperature (if outdoor sensor is fi tted) and to
show the Service Due Date if set. Below is a more detailed
explanation of operation:
If no outdoor sensor is fi tted:
Pressing the INFO button will display the time of the next
event according to the programmed times. The event
time shown will include any +HRS or BOOST extensions. If
the next event time is shown fl ashing, this represents an
approximate time due to Optimum Start, Delayed Start or
a timed override being active.
i
To Next Page
Loading...
