Danfoss TP9000 - Changing the preset programmes in 7 day mode; Changing the preset programmes in 5;2 day mode

GB
PL
DANFOSS HEATING 21
Before beginning programming the unit remember to check that the
correct function is selected i.e. Heating or Hot Water by using the CH/
HW button.
Changing the preset programmes in 7 day mode
a) Press PROG once until the display shows the
fi rst preset time and temperature
b) Use the + and - buttons to adjust the time
(press and hold to adjust in 10 minute increments)
c) Use the Λ and V buttons to adjust the required temperature (CH
only)
d) Press NEXT to move to the next preset time
and/or temperature (Event 2)
e) Once all events for the day have been
programmed, press DAY/HOL to move to the next day
f) Repeat steps b, c, d & e to programme the remaining weeks
events.
g) Press and hold PROG to return to the main screen.
Changing the preset programmes in 5/2 day mode
For Weekdays
a) Press PROG until the fi rst preset time and
temperature (Event 1 Days MON, TUE, WED,
THU, FRI)
b) Use the + and - buttons to adjust the TIME (press and hold to
change in 10 minute increments).
c) Use the Λ and V buttons to adjust the required TEMPERATURE (CH
only).