Danfoss TP9000 User Manual

TP9000
30
Temporary override buttons
Sometimes you may need to change the way you use your
Heating temporarily, i.e. due to unusually cold weather. The
TP9000 has two convenient overrides which can be selected
without aff ecting the set programme.
The grey buttons next to the radiator and tap symbol is
the + HRS button for heating and the BOOST button for
the Hot Water.
For Water display mode, pressing this button once, twice or
three times when the system is in OFF, AUTO or ALLDAY
mode will cause the Hot Waterto remain on for an extra 1,
2 or 3 hours if already on, or will switch the water on for 1, 2
or 3 hours if currently off . BOOST +1, +2 or +3 HRS will be
shown in the display.
For Heating display mode, pressing the +HRS button
once, twice or three times will extend the current
time/temperature period for 1, 2 or 3 hours, but does
not operate if the thermostat is in the OFF or FROST
PROTECTION mode. +1, +2 or +3 HRS will be shown in the
display. Pressing this button for a fourth time will cancel
the +HRS BOOST function.
+1/+2/+3 hr
override
Mode select
button (auto/all
day/on/off )
CH/HW
button
Temperature
adjustment
buttons
INFO button
RESET
+ HRS
BOOST

Danfoss TP9000 Specifications

General

Display	LCD
Temperature Control Accuracy	±0.5°C
Protection Class	IP30
Type	Programmable Thermostat
Programming	7-day programming
Temperature Range	5°C to 30°C
Battery Type	2 x AA
Power Supply	Battery-powered
Installation	Easy installation