Danfoss Turbocor TT-300 User Manual

Contents
Danfoss Turbocor Compressors Inc. i
ECD-00007M Rev. 1
Introduction 1
System Requirements 2
Getting Started 3
Cable Connection 3
RS232 Connection 3
RS485 Connection 3
Monitor Program Installation 5
Starting the Monitor Program 5
User Interface 5
Monitor Program Toolbar 5
Entering User Input 6
Serial Port Connection 6
Compressor Configuration 7
Using the Setup Wizard 7
Start-up Settings 8
Electronics Valve Control 9
Analog Output Setup 11
Modbus Communications 12
Downloading and Saving Configuration Data 12
Using a Saved Configuration File 13
Controlling User Access 14
Starting and Stopping the Compressor 15
Analog Input 15
How to Start the Compressor 15
How to Stop the Compressor 15
Modbus Network 15
How to Start the Compressor 15
How to Stop the Compressor 16
Chiller Control 16
How to Start the Compressor 16
How to Stop the Compressor 16
Monitor Program Data and Controls 18
Main System 18
Bearing Calibration 20
Bearing Calibration Procedure 22
Calibration Data Interpretation 23
“Gain” Interpretation 23
“Offset” Interpretation 23
Compressor Control 23
Compressor Control Modes 26
Calibration 26
Manual Control 26
Analog Input 27
Modbus Network 27
Chiller Control 27
Compressor Faults/Alarms 27

Danfoss Turbocor TT-300 Specifications

General

Brand	Danfoss
Model	Turbocor TT-300
Category	Air Compressor
Language	English