Service Monitor User Manual
Danfoss Turbocor Compressors Inc. 37
ECD-00007M Rev. 1
To view the “Chiller Control” window, select “Window”→
“Chiller Control” from the menu bar, or click on the
“Chiller Control” icon located below the menu bar. Table 14
provides details about the chiller controller parameters.
NOTE:
The measurement unit (metric/imperial) displayed depends
on the measurement unit previously set. To verify or change
the measurement unit, refer to section 6.3 "Compressor
Control" on page 23.
IMPORTANT:
To change a parameter setting, double-click the variable
field, scroll or type in the new setting, and press Enter. It is
important to press Enter as this causes the user input to be
validated.
Figure 28 Chiller Control Form
To Next Page
Loading...
