EasyManuals Logo

Danfoss vlt aqua Programming Guide

Danfoss vlt aqua
298 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #109 background imageLoading...
Page #109 background image
8-05 End-of-Timeout Function
Option: Function:
[0] Hold set-up Retains the set-up selected in par. 8-04 and displays a warning,
until par. 8-06 toggles. Then the frequency converter resumes
its original set-up.
[1]
*
Resume set-up Resumes the set-up active prior to the time-out.
Select the action after receiving a valid control word following a
time-out. This parameter is active only when par. 8-04 is set to
[Set-up 1-4].
8-06 Reset Control Timeout
Option: Function:
[0]
*
Do not reset Retains the set-up specified in par. 8-04, [Select setup 1-4] fol-
lowing a control time-out.
[1] Do reset Returns the frequency converter to the original set-up following
a control word time-out. When the value is set to
Do reset
[1],
the frequency converter performs the reset and then immedi-
ately reverts to the
Do not reset
[0] setting.
This parameter is active only when the choice
Hold set-up
[0]
has been selected in
par. 8-05 End-of-Time-out Function
.
8-07 Diagnosis Trigger
Option: Function:
[0]
*
Disable
[1] Trigger on alarms
[2] Trigger alarms/warn.
This parameter has no function for LonWorks.
2.9.3. 8-1* Ctrl. Word Settings
Parameters for configuring the option control word profile.
8-10 Control Word Profile
Option: Function:
[0]
*
FC profile
Select the interpretation of the control and status words corre-
sponding to the installed fieldbus. Only the selections valid for
the fieldbus installed in slot A will be visible in the LCP display.
VLT
®
AQUA Drive Programming Guide 2. Parameter Description
MG.20.O2.02 - VLT
®
is a registered Danfoss trademark
109
2

Other manuals for Danfoss vlt aqua

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Danfoss vlt aqua and is the answer not in the manual?

Danfoss vlt aqua Specifications

General IconGeneral
Supply Voltage200-240V, 380-500V, 525-600V
EnclosureIP20
FeaturesEnergy optimization
ApprovalsCE, UL, cUL
Input Voltage Range200-240V, 380-500V, 525-600V
Output Voltage Range0 to supply voltage
Protection FeaturesOvervoltage, Undervoltage, Overcurrent, Short circuit, Ground fault
Communication InterfacesPROFIBUS
Cooling MethodAir-cooled

Related product manuals