Danfoss vlt aqua Programming Guide

Par. No. # Parameter description Default value 4-set-up Change during
operation
Conver-
sion index
Type
29-0* Pipe Fill 29-00 Pipe Fill Enable Disabled All set-ups TRUE - - 29-01 Pipe Fill Speed [RPM] Motor Speed Low Limit All set-ups TRUE - -
29-02 Pipe Fill Speed [Hz] Motor Speed Low Limit All set-ups TRUE - -
29-03 Pipe Fill Time 0 All set-ups TRUE - -
29-04 Pipe Fill Rate -All set-upsTRUE--
29-05 Filled Setpoint 0 All set-ups TRUE - -
3.1.23. 29-** Water Application Functions
VLT
®
AQUA Drive Programming Guide 3. Parameter Lists
MG.20.O2.02 - VLT
®
is a registered Danfoss trademark 287
3

Danfoss vlt aqua Specifications

General

Supply Voltage	200-240V, 380-500V, 525-600V
Enclosure	IP20
Features	Energy optimization
Approvals	CE, UL, cUL
Input Voltage Range	200-240V, 380-500V, 525-600V
Output Voltage Range	0 to supply voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Short circuit, Ground fault
Communication Interfaces	PROFIBUS
Cooling Method	Air-cooled