[1666] Digital Output [bin] Binary value of all digital outputs.
[1667] Freq. Input #29 [Hz] Actual value of the frequency applied at terminal 29 as a pulse
input.
[1668] Freq. Input #33 [Hz] Actual value of the frequency applied at terminal 33 as a pulse
input.
[1669] Pulse Output #27
[Hz]
Actual value of pulses applied to terminal 27 in digital output
mode.
[1670] Pulse Output #29
[Hz]
Actual value of pulses applied to terminal 29 in digital output
mode.
[1671] Relay Output [bin] View the setting of all relays.
[1672] Counter A View the present value of Counter A.
[1673] Counter B View the present value of Counter B.
[1675] Analog input X30/11 Actual value of the signal on input X30/11 (General Purpose I/
O Card. Option)
[1676] Analog input X30/12 Actual value of the signal on input X30/12 (General Purpose I/
O Card. Optional)
[1677] Analog output X30/8
[mA]
Actual value at output X30/8 (General Purpose I/O Card. Op-
tional) Use Par. 6-60 to select the variable to be shown.
[1680] Fieldbus CTW 1 Control word (CTW) received from the Bus Master.
[1682] Fieldbus REF 1 Main reference value sent with control word via the serial com-
munications network e.g. from the BMS, PLC or other master
controller.
[1684] Comm. Option STW Extended fieldbus communication option status word.
[1685] FC Port CTW 1 Control word (CTW) received from the Bus Master.
[1686] FC Port REF 1 Status word (STW) sent to the Bus Master.
[1690] Alarm Word One or more alarms in a Hex code (used for serial communica-
tions)
[1691] Alarm Word 2 One or more alarms in a Hex code (used for serial communica-
tions)
[1692] Warning Word One or more warnings in a Hex code (used for serial communi-
cations)
[1693] Warning Word 2 One or more warnings in a Hex code (used for serial communi-
cations)
[1694] Ext. Status Word One or more status conditions in a Hex code (used for serial
communications)
[1695] Ext. Status Word 2 One or more status conditions in a Hex code (used for serial
communications)
[1696] Maintenance Word The bits reflect the status for the programmed Preventive Main-
tenance Events in parameter group 23-1*
[1830] Analog Input X42/1 Shows the value of the signal applied to terminal X42/1 on the
Analog I/O card.
VLT
®
AQUA Drive Programming Guide 2. Parameter Description
MG.20.O2.02 - VLT
®
is a registered Danfoss trademark
33
2
To Next Page
Loading...
