Danfoss VLT AutomationDrive FC 300 Series Programming Guide

Parameter 18-00 Maintenance Log: Item
Table 966: Parameter 18-00 Maintenance Log: Item
18-00 Maintenance Log: Item
Default value: 0
Parameter type: Range, 0 - 255, Array [10]
Setup: All setups
Conversion index: 0
Data type: Uint8
Change during operation: False
Shows the fault code. See the different maintenance items in parameter 23-10 Maintenance Item.
Parameter 18-01 Maintenance Log: Action
Table 967: Parameter 18-01 Maintenance Log: Action
18-01 Maintenance Log: Action
Default value: 0
Parameter type: Range, 0 - 255, Array [10]
Setup: All setups
Conversion index: 0
Data type: Uint8
Change during operation: False
Shows the fault code. See the different maintenance actions in parameter 23-11 Maintenance Action.
Parameter 18-02 Maintenance Log: Time
Table 968: Parameter 18-02 Maintenance Log: Time
18-02 Maintenance Log: Time
Default value: 0 s
Parameter type: Range, 0 - 2147483647 s, Array [10]
Setup: All setups
Conversion index: 0
Data type: Uint32
Change during operation: False
Shows when the logged event occurred. Time is measured in s since last power-up.
Parameter 18-03 Maintenance Log: Date and Time
Table 969: Parameter 18-03 Maintenance Log: Date and Time
18-03 Maintenance Log: Date and Time
Default value: Size related
Parameter type: Range, 0 - 0, Array [10]
Setup: All setups
Conversion index: 0
Data type: TimeOfDay
Change during operation: False
Shows when the logged event occurred.
N O T I C E
This requires that the date and time is programmed in parameter 0-70 Date and Time.
Date format depends on the setting in parameter 0-71 Date Format, while the time format depends on the setting in parameter 0-72
Time Format.
N O T I C E
The drive has no back-up of the clock function. The set date/time resets to default (2000-01-01 00:00) after a power-down unless
a real-time clock module with back-up is installed. In parameter 0-79 Clock Fault, it is possible to program a warning in case the
clock has not been set properly, for example after a power-down. Incorrect setting of the clock affects the time stamps for the
maintenance events.
N O T I C E
When mounting a VLT® Analog I/O MCB 109 option card, a battery back-up of date and time is included.
AU275636650261en-000101 / 130R0334538 | Danfoss A/S © 2022.12
Parameter Descriptions
VLT AutomationDrive FC 301/302
Programming Guide

Danfoss VLT AutomationDrive FC 300 Series Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300 Series
Category	DC Drives
Language	English